shift-i-curved
Shiftlights
!

Shift-i sequential shiftlight

shift-i
A while back we bought one of these shiftlights to fit to one of our own cars. After they saw it our friends wanted them and asked us to import some for them. Before we knew it we had dozens of their friends asking for them too. The rest, as they say, is history and we're now an official dealer for the Shift-I.

With just 3 wires to connect (power, ground and tacho) shiftlights don't come easier to set up than this.  Set the RPM that you want the first light to come on, then set the point when you want the last to light up using the buttons on the front panel - not by revving the engine.  Since the Shift-i takes its feed from your tacho wiring it does not need an ECU that has a shiftlight output to control it.  As a result it can be used equally well with carbs or with any fuel injection and engine management system.

  • Digital RPM Range selection
  • Super bright for daytime use!!!
  • 9 different display modes
  • Adjustable/Automatic dimming
  • Battery monitoring functions.
  • Only 3 wires to connect!
  • Packed with features
  • Designed for both novice and professional use.

Red/Green Cluster LED

Shift-RG-LED
shiftlight-red-green

26mm cluster lamp with 14 super-bright LEDs - 6 red and 8 green.  Suitable for a range of uses this cluster is most commonly used as a shift light or oil pressure warning lamp.

When used with an ECU that has programmable outputs (such as our Megajolt ignition system) this can be used as a low-cost sequential shift light.  For example if your rev limit is 6500rpm you might do the following:

  • Under 5000rpm all programmable outputs off
  • Between 5000 and 5500rpm user output 1 is on to turn on green LEDs
  • Between 5500 and 6000rpm user output 2 is on to turn on red LEDs
  • Above 6000rpm output 3 is on and turns on both red and green LEDs

Wiring information:

  • White wire 12 volt positive power source
  • Green wire - Switch to ground via 100 ohm resistor to turn on green LEDs
  • Red wire - Switch to ground via 130 ohm resistor to turn on red LEDs